Instructors:

Normally each course uses two instructors.  This adds value in two ways.  (1) The second instructor brings unique experience and knowledge to the class room, and (2) Student attention span suffers when a single instructor presents the entire course.  When the class is composed of fewer than 25 students Dr Doyle can serve as a single instructor for all of the courses except CAM. - Title V Monitoring.  Doyle Engineering Inc can provide the coordination with, and remuneration of all instructors for any course.

Brian Doyle, PhD

Dr. Doyle is a consulting engineer with 40 years experience in air pollution control.  He has supported Rutgers University air pollution training since 1976.  Initially this consisted of half day lectures to bring real world experience to classes taught by Rutgers faculty.  In 1992 this occasional work expanded when Dr. Doyle became responsible for the development and regular presentation of a three day course titled Combustion Source Inspection.  The success of this course lead to the development and regular presentation of three additional courses for the Rutgers Air Compliance Center.  In 2002, under subcontract to the EPA he wrote the Student Manual and presentation slides for APTI 427 - Combustion Source Evaluation.  While the Rutgers Air Compliance Center, that has provided administrative organization and support for four of these courses, may cease operation at the end of fiscal 2007, Dr. Doyle continues to be available to teach air pollution training courses.  Presentations by Dr. Doyle can be custom tailored to student needs or can be substantially the same as it was when they were offered through Rutgers.


Robert Machaver

Mr. Machaver is a consultant who specializes in emission monitoring and data management systems.  He developed the presentation slides for the Emissions Calculations course and has been the supporting instructor with Dr. Doyle for the Combustion Source Inspection course.


Gary Saunders, NC DNR

Mr. Saunders is an engineer with the State of North Carolina who manages a variety of special projects.  He has many years experience inspecting and assessing the emissions performance of a wide variety of industrial facilities.  He has developed a variety of training courses and presented them to numerous classes.   He participates in these courses on his own time with the knowledge of his employer and in venues where his participation is not viewed as a conflict of interest.


Chuck Solt

Mr Solt is a consulting engineer with experience in a variety of industries.  He is particularly familiar with engine/turbine emission characteristics and with current permitting requirements for power plants and industrial facilities.  He has been the supporting instructor with Dr. Doyle in teaching both the Combustion Source Inspection and the NOx emissions courses.

http://www.lindhandassociates.com/Chuck.htm